The steps are as follows: 1. Before producing accessories, the factory design department should first take out the design drawings and manufacture molds according to the drawings. This is the most important process that must be done well and refined. After the mold is completed, it will be transferred to the next connecting department according to the product category. If the mold is of chain structure (necklace, bracelet, foot chain, etc.), it is transferred to the material preparation department; if it is of ring, bracelet, pendant, gold bar, etc., it is transferred to the oil pressure department 2. In the material preparation department, the staff process the prototype of products according to the mold, that is, semi-finished products or accessories, including Necklace accessories, small round beads or olive beads. Then, these semi-finished products will be transferred to the chain to connect each part of the necklace, thus forming a preliminary complete necklace 3. The work content of the oil pressure department is the same as that of the material preparation department. It is also the rudiment of processing and production products. Once the prototype is available, it will be sent to the mold holding department for reshaping, so that the shape of gold jewelry such as rings and bracelets will be closer to the shape of the finished product 4. Finally, the gold jewelry should be sent to the electric gold department for polishing and calendering, that is, to remove some impurities and dust on the surface of the gold jewelry. After further processing by professional technology, it can achieve the best effect of a finished gold jewelry.
The steps are as follows:
1. Before producing accessories, the factory design department should first take out the design drawings and manufacture molds according to the drawings. This is the most important process that must be done well and refined. After the mold is completed, it will be transferred to the next connecting department according to the product category. If the mold is of chain structure (necklace, bracelet, foot chain, etc.), it is transferred to the material preparation department; if it is of ring, bracelet, pendant, gold bar, etc., it is transferred to the oil pressure department
2. In the material preparation department, the staff process the prototype of products according to the mold, that is, semi-finished products or accessories, including Necklace accessories, small round beads or olive beads. Then, these semi-finished products will be transferred to the chain to connect each part of the necklace, thus forming a preliminary complete necklace
3. The work content of the oil pressure department is the same as that of the material preparation department. It is also the rudiment of processing and production products. Once the prototype is available, it will be sent to the mold holding department for reshaping, so that the shape of gold jewelry such as rings and bracelets will be closer to the shape of the finished product
4. Finally, the gold jewelry should be sent to the electric gold department for polishing and calendering, that is, to remove some impurities and dust on the surface of the gold jewelry. After further processing by professional technology, it can achieve the best effect of a finished gold jewelry.